PAINT SPRAY

DIRECTIONS FOR USE

All surfaces must be free of any grease, dirt, rust, moisture, loose paint, or
any other material which might interfere with proper adhesion. Glossy
surfaces must be dulled by light sanding. Metals should be rust free and
primer should be used for best results. Cover adjacent areas with Abro
Masking tape to protect from spray mist. Use at room temp.
Shake can vigorously for one minute before spraying and occasionally
while in use to ensure color uniformity and prevent clogging.
On previously painted surface test spray in a small inconspicuous area.
Hold can 12-16 inches from surface to be sprayed.
Press spray button rmly with steady even strokes while moving can
rapidly back and forth. Finger must not protrude over front edge of spray
button. 2 or 3 thin coats with intermittence of 10 min. are better than one
continuous heavy coat.
Should paint bubble or run, you are too close to the surface or spraying
too heavy coat.
After use, turn can upside down and depress valve button for several
seconds to clear valve until only gas emerges so as to prevent clogging.
Discard empty can in trash pickup. Do not place in home garbage compactor or burn.

Download